The Arc Zone Characteristics Of The Zinc Sprayer Can Improve The Expected Goals Of Atomization

The zinc spraying machine can evenly feed the top of the wire in the whole process of working, melt the polymer material of the metal material and atomize the whole process. So what are the factors affecting the atomization of the zinc sprayer?

The total flow of the cyclone

The actual expected effect of atomization is very closely related to the total cyclone flow. If the total gas flow is too large, it can ensure that the particles are accelerated and the particles are evenly distributed. To ensure the reduction of the gas, it will undoubtedly increase the product cost.

Second, the performance indicators of molten wire

The key performance indicators of molten wire refer to viscosity and interfacial tension. The larger the viscosity and interfacial tension of the droplet, the thicker the atomized particles. If the zinc spraying machine has low viscosity and low interfacial tension, the molten metal material polymer material is very easy to deform; the low viscosity of the zinc spraying machine improves the variability of the droplets in the segment, making the droplets crack.

3. Characteristics of arc area

If the temperature of the arc area of the zinc spraying machine is higher, the cyclone temperature raising effect on the wire joint material will be stronger, and the melting of the wire material also has a very large atomization cyclone rate, atomization cyclone temperature and arc area temperature distribution. association. The arc zone characteristics of the zinc sprayer can improve the desired goal of atomization.

The structure of the zinc spraying machine is composed of the sound card frame, the clamping and rotating structure, the lifting part, the zinc spraying structure, the automatic automatic control system of the hydraulic press and the software of the smoke acquisition system. The cast pipe from the quenching furnace travels along the non-push guide rail according to the transport car, and reaches the zinc spraying process. During the lifting structure work, the cast pipe is sent to the clamped aspect ratio.